Suitable for the hot-end heater block of Creali CR6 SE/CR-6 MAX/CR-5 Pro. If you want to install for other printers, make sure that the correct connector and the correct heater block hole, the correct cable length.Thermistor sensor: Built-in NTC100K thermistor, the head is a full metal barrel on the thermistor.Head size: φ3X5mm; terminal XH2.54, 2PIN male head with terminal; cable length: about 74 mm/2.9 inchescolour:As shownMaterial:Metal + plasticPackage Contents:1 x Applicable to CR-6SE HT-NTC100K thermistor sensorOnly the above package content, other products are not included.Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.