Description

ESP32-CAM Camera Module WiFi Bluetooth Development Board ESP32 Wireless OV2640 Camera Module with Jumper Wire

Product Description

ESP32 CAM WiFi Bluetooth Module:

Ultra-small 802.11b/g/n Wi-Fi BT/BLE SoC module

Low-power dual-core 32-bit CPU for application processors

Up to 240MHz, up to 600 DMIPS

Built-in 520 KB SRAM, external 4M PSRAM

Supports interfaces such as UART/SPI/I2C/PWM/ADC/DAC

Support OV2640 and OV7670 cameras with built-in flash

Support for images WiFI upload

Support TF card

Support multiple sleep modes

Embedded Lwip and FreeRTOS

Support STA/AP/STA AP working mode

Support Smart Config/AirKiss One-click distribution network

Support for serial local upgrade and remote firmware upgrade (FOTA)

Quantity:

1pcs x esp32-cam module

1pcs x 20cm 20pin dupont wire (female)

1pcs x 20cm 20pin dupont wire (male)

There are three GND pins and two pins for power: either 3.3V or 5V.

GPIO 1 and GPIO 3 are the serial pins. You need these pins to upload code to your board.

Additionally, GPIO 0 also plays an important role, since it determines whether the ESP32 is in flashing mode or not. When GPIO 0 is connected to GND, the ESP32 is in flashing mode.

The following pins are internally connected to the microSD card reader:

GPIO 14: CLK

GPIO 15: CMD

GPIO 2: Data 0

GPIO 4: Data 1 (also connected to the on-board LED)

GPIO 12: Data 2

GPIO 13: Data 3